Donner Beat - Page 13

Proportion of FILTER channels
Click on the parameter drag option in this interface for selection, push the
fader within the option, or use the encoder to adjust the parameters.
Restore
Current FILTER parameter is restored to the default parameter
FILTER current channel switch
For FILTER parameter adjustment, the button must be “ON” for valid operation.
FILTER Type Selection
Click it to pop up type selection
Lowpass: Lowpass filtering
Bandpass: Bandpass filtering
Highpass: Highpass filtering
COMPRESSOR parameter adjustment
Click on the parameter drag option in this interface for selection, push the
fader within the option, or use the encoder to adjust the parameters.
Type:
Classic - compresses the input signal directly
Feedback - compresses by feeding a portion of the output back to the input;
slight variations in transient shaping and frequency response may occur.
Restore
Currently selected effect kit is restored to the default parameter
COMPRESSOR current channel switch
For COMPRESSOR parameter adjustment, the button must be “ON” for valid operation.
COMPRESSOR Type Selection
Click it to pop up type selection
Classic: Directly use input signals for compression
Feedback: Some outputs are sent to the input end for compression, while the
transitional shape and frequency response may have slight changes
❹
FILTER Effect Buttons
FILTER Parameter Adjustment
11
Off On Parameter adjustment
Type
Input Gain
Thresh
Knee
Attack Time
Release Time
Output Gain
Parameter
-60dB --10dB
-60dB --0dB
0%--100%
0.1ms --8ms
40ms --251ms
36dB --0dB
Description
--
The value determines the beginning input volume of the compressor
The value determines the flatness of compressed volume changes; the larger the value is, the more prominent the
sudden changes are.
The value determines the waiting time to be valid after the compressor receives input signals.
The value determines the waiting time for the compressor to stop operation after the signals attenuation is below the
Thresh.
--