Donner Beat - Page 14

Restore
Current FX SEND parameter is restored to the default parameter
Proportion of FX SEND channels
Click on the parameter drag option in this interface for selection, push the
fader within the option, or use the encoder to adjust the parameters.
❺
FX SEND Parameter Adjustment
Off On
Parameter adjustment
12
Restore
Current REVERB parameter is restored to the default parameter
REVERB current channel switch
For REVERB parameter adjustment, the button must be “ON” for valid operation
REVERB Type mode selection
Click it to pop up mode selection
Room: Room reverberation
Hall: Hall reverberation
Church: Church reverberation
Plate: Plate reverberation
Spring: Spring reverberation
FILTER parameter adjustment
Click on the parameter drag option in this interface for selection, push the
fader within the option, or use the encoder to adjust the parameters.
❻
REVERB Effect Button + Picture
Off On Parameter adjustment
Type
Snare
Kick
Toms
Cymbals
Backing
Parameter
0 -- 100
0 -- 100
0 -- 100
0 -- 100
0 -- 100
Description
Snare channel
Kick channel
Mixed channel of all Toms
Mixed channel of all Cymbals
Background music channel
Type
Frequency
Resonance
Parameter
46Hz --12500Hz
0--100
Description
Filter cut-off frequency
Nearby gain of filter cut-off frequency
Range of filter cut-off frequency modulation: No modulation is made if it is 0; if it is larger than 0, the modulation is
made from filter cut-off frequency to the direction larger than the frequency; when it is +100, the positive
modulation amount reaches the maximum, namely from Frequency to 12500Hz; if it is less than 0, the modulation is
made from the frequency to the direction less than the frequency; when it is -100, the negative modulation amount
reaches the maximum, namely from Frequency to 46Hz; the modulation frequency is 3Hz.
Mod Amount
-100--0--+100