2.8 Miscellaneous
2.8.1 Restore Defaults
This step will restore the factory set defaults for each of the programming parameters.
WARNING: Once started, this sequence will program all values to factory default.
1. Press * 9 0 and enter the MASTER CODE. [ * 9 0 _ _ _ _ (beep)]
2. Press 9 9 9 9 then press *. [ 9 9 9 9 * (beep)]
3. This sequence will end itself automatically. [beeeeeep]
2.8.2 Erase Transaction Log
This step will erase (empty) the transactions stored in the system history buffer (the system stores up
to 500 transactions).
WARNING: Transaction log cannot be recovered after this sequence is started.
1. Press * 9 1 and enter the MASTER CODE. [ * 9 1 _ _ _ _ (beep)]
2. Press 9 9 9 9 then press *. [ 9 9 9 9 * (beep)]
3. This sequence will end itself automatically in about 3 seconds. [beeeeeep]
1810-162-L-5-15 Page 49
To Next Page
Loading...
