ENGINE DISASSEMBLY
- 48 -
3.1.39. Cylinder liner
Disassemble the cylinder liner using a liner
puller.
3.1.40. Fly wheel
Position the engine so that the head
installing surface of the cylinder block faces
down.
Unscrew the flywheel fixing bolts and fit a
dowel pin.
Install flywheel disassembling bolts in the
bolt holes machined on the flywheel, and
disassemble the flywheel.
3.1.41. Oil seal
Take off the rear oil seal using an oil seal
disassembling jig.
If only the inside guide ring is removed, use
a special tool to take off the outside seal.
3.1.42. Flywheel housing
Loosen the housing fixing bolts and
disassemble the flywheel housing.
To Next Page
