ENGINE DISASSEMBLY
- 67 -
z
Apply engine oil to the entire face of the tappets
and slide them into the tappet holes on the
cylinder block.
z
Wet the cam bush inside diameter and
camshaft with oil, and carefully assemble them
while turning the camshaft.
z
Check to see that the camshaft rotates smoothly.
3.3.5. Crankshaft
z
Install the main bearing machined with two
holes in the cylinder block so that the key is
aligned with the key groove, then apply oil to
the bearing surface.
z
Heat the crankshaft gear for at least 10 minutes
to 120°C, then apply sealant (Loctite # 641) to
the inside wall of the heated crankshaft gear
evenly before inserting it to the end of crankshaft.
EDM2060I
EA0M4083
Oil port and passage
Key groove
EA8M3014
To Next Page
