DL06K Interim Tire-4 Diesel Engine Disassembly and Reassembly of Major Components
92
z Install the oiled thrust washers with
the oil groove facing outward.
z Install the bearing and thrust washers
to the bearing cap and apply oil to the
bearing and thrust washers.
z Install the bearing cap by matching
the cylinder block No. with the bearing
cap No.
z Apply oil to the entire part of the bearing
cap bolts, then tighten in tightening
sequence to specified torque.
z After semi-tightening both bolts evenly,
tighten them diagonally to the
specified torque using a torque
wrench as follows.
Torque 30 kgf•m
EAMD076S
EAMD077I
EH8OM018
Tightening order
Bearing cap
1 2 3 4 5 6 71234567
EH8OM017
To Next Page
Loading...
