SP002050
Page 9
Wheel Loader Safety
GENERAL SAFETY ESSENTIALS
Accessory Applications
This wheel loader has been designed primarily for moving earth
with a bucket. For use as a grapple or for other object handling,
contact DOOSAN. Lifting-work applications are permitted in
approved lift configuration, to rated capacity only, with no
side-loading (unless prohibited by local regulation). Do not use
machine for activities for which it was not intended. Do not use
bucket for lifting work, unless lift slings are used in approved
configuration.
LOCATION OF SAFETY LABELS
Location of safety labels (decals) can vary from unit to unit.
Refer to appropriate Operation and Maintenance Manual, and
Parts Manual for your unit.
There are several specific warning signs on this machine. The
exact location of hazards and the description of the hazards are
reviewed in the appropriate Operation and Maintenance Manual.
Please become familiarized with all warning signs.
Make sure that all the warning signs are legible. Clean the
warning signs or replace the warning signs if you cannot read
the words. Replace the illustrations if the illustrations are not
visible. When you clean the warning signs, use a cloth, water
and soap. Do not use solvent, gasoline, or other harsh
chemicals to clean the safety signs. Solvents, gasoline, or other
harsh chemicals could loosen the adhesive that secures the
warning sign. Loose adhesive will allow the warning sign to fall
off.
Replace any safety sign that is damaged, or missing. If a safety
sign is attached to a part that is replaced, install a safety sign on
the replacement part.
To Next Page
Loading...
