SP002667Wheel Loader Safety
Page 20
OPERATION
Always make sure that the machine is properly maintained.
Before Engine Starting
Machine Condition
Every day before starting engine for first time, perform the
following checks and repair machine before operating, as
necessary. If these checks are not properly done death or
serious injury could result.
• Check coolant, fuel, and hydraulic tank oil levels, and
check for clogged air cleaner and damage to
electrical wiring.
• Check operation of gauges, cameras (if equipped)
and angle of mirrors, and check that pilot cutoff
switch is set to "O" (OFF) position.
• Check that pedals move freely, and pilot control lever
(s) returns to "NEUTRAL" when released.
• Check that attachment is properly attached and
locked.
Make sure that the machine is equipped with a lighting system
that is adequate for job conditions and check that the lights are
working properly.
Before performing checks, move machine to an area where
there are no obstructions, and operate slowly. Do not allow
personnel near machine.
Know maximum operating dimensions of your machine.
Work Site
Before starting operations, thoroughly check work area for any
hazards, such as underground utility lines, overhead electrical
lines, unstable ground, excessive slopes, etc.
Before starting engine and moving machine, make sure that no
one is underneath machine, around machine, or on machine.
Know width and length of your machine and work equipment to
maintain proper clearance when you operate machine or work
equipment near fences or near boundary obstacles.
IMPORTANT
Only use Ultra Low Sulfur Diesel (ULSD) fuel and
API-CJ-4/ACEA-E9 grade engine oil.
FG013735
No Entry
WARNING
Figure 16
To Next Page
Loading...
