SP002667Wheel Loader Safety
Page 24
Visibility Information
A rear view camera (if equipped) and mirrors provide the
operator with additional means to see the work area.
NOTE: These devices may vary from one region to another,
depending upon local and regional laws and
regulations. If a machine is moved or sold into
another region or marketplace, it is the owner's
responsibility to make sure it complies with all
applicable laws and regulations.
Your machine may be equipped with visual aids such as mirrors
or a rear view camera. Even with these aids, there still may be
areas around the machine which cannot be seen from the
operator's seat. Always keep bystanders out of the work area.
Be careful when operating and always look in direction of travel.
Adjust visual aids for best visibility around machine.
When backing up, press camera button (if equipped) to change
display mode on display monitor so you can check rear and side
of machine.
Before moving machine, look around work site and use mirrors
and display monitor to confirm that no one is in the work area.
While operating or traveling in places with poor visibility it may
be impossible to confirm condition of the work site. Inspect and
remove any obstacles around the machine that could be
damaged and keep other personnel and bystanders out of the
work area.
Inspect equipment and repair immediately if there are problems
with visual aids. If machine cannot be fixed immediately, DO
NOT use the machine. Contact your DOOSAN distributor and
arrange for repairs.
WARNING
AVOID DEATH OR SERIOUS INJURY
Failure to check for and clear people from the surrounding
area of a machine can result in death or serious injury. The
operator should make sure that visual aids (mirrors and
camera(s)) are in proper working condition.
To Next Page
Loading...
