Operating & Maintenance Manual Noise Emission
24
NOISE EMISSION CONTROL MAINTENANCE LOG
The Noise Control Act of 1972 (86 Stat. 1234) prohibits tampering with the noise control
system of any compressor manufactured and sold under the above regulations, specifically
the following acts or the causing thereof:
(1) The removal or rendering inoperative by any persons, other than for purposes of
maintenance, repair, or replacement, of any device or element of design incorporated into any
new compressor for the purpose of noise control prior to its sale or delivery to the ultimate
purchaser or while it is in use; or (2) the use of the compressor after such device or element
of design has been removed or rendered inoperative by any person.
Noise Emission Warranty
The manufacturer warrants to the ultimate purchaser and each subsequent purchaser that this
air compressor was designed, built and equipped to conform at the time of sale to the first retail
purchaser, with all applicable U.S. EPA Noise Control Regulations.
This warranty is not limited to any particular part, component, or system of the air compressor.
Defects in the design, assembly or in any part, component, or system of the compressor
which, at the time of sale to the first retail purchaser, caused noise emissions to exceed
Federal Standards are covered by this warranty for the life of the air compressor.
(40FR204.58-1).
COMPRESSOR MODEL_________________________
SERIAL NO. __________________________________
USER UNIT NO. _______________________________
UNIT IDENTIFICATION
ENGINE MAKE & MODEL:
DEALER OR DISTRIBUTOR FROM
WHOM PURCHASED:
SERIAL NO:_________________ __________________________________
PURCHASER OR OWNER:__________ __________________________________
ADDRESS: ____________________ DATE PURCHASED:_______________
To Next Page
Loading...
