1. Introduction
MIDI Foot Controller (FC-3) is a MIDI controller designed by DOREMiDi that can be
used for foot control. FC-3 has a variety of MIDI output interfaces, which can be connected
to computers, USB MIDI instruments, and MIDI DIN devices. FC-3 has 3 programmable
switch pedals and 1 expression pedal interface, all pedals can be customized with MIDI
messages, and each pedal can be configured with 16 groups of MIDI. The FC-3 has a
display that clearly shows the MIDI messages currently being played.
2. Appearance
❶ DC IN: Product power supply interface, use DC plug to supply power to the product,
power supply voltage 5V~12V. ( Center-positive power supply)
❷ USB DEVICE: USB device interface, use a USB cable to connect to the computer, you
can also supply power to the FC-3 through this interface.
❸ USB HOST: USB host interface, use a USB cable to connect a device with a USB MIDI
interface.
❹ MIDI OUT: MIDI DIN output interface, use a 5-pin MIDI cable to connect devices with
MIDI IN.
❺ 4/EXP: Pedal Number: 4, Expression pedal interface, connect the analog expression
pedal through 6.35mm TRS cable.
❻❼❽1/-, 2/Shift, 3/+: Pedal Number: 1~3, Switch Pedal, output MIDI messages by
stepping on it.
❾ Display: OLED display, showing the working content of FC-3.
3. Product Parameters
To Next Page
Loading...
