EN
G-EMR XEA
Mounting instructions
dormakaba Deutschland GmbH
DORMA Platz 1
58256 Ennepetal
DIN EN 14637:2008-01 3 8 1 1 1 4
dormakaba Deutschland GmbH
DORMA Platz 1
58256 Ennepetal
17
0432-CPR-00026-60 EN 1155 1997/A1: 2002/AC:2006 3 8 3-5 1 1 4
DOP_0148
Contents
1 About this manual 2
1.1 Information about the manual 2
1.2 Target groups 2
1.3 Provided documents 2
1.4 Symbols and abbreviations used 2
1.4.1 Safety instructions 2
1.4.2 Further labeling 2
1.4.3 Tool symbols 2
1.5 Glossary 2
2 Safety 3
2.1 Intended use 3
2.2 Foreseeable misuse 3
2.3 Limitation of liability 3
2.4 Prerequisites for the operation of catching
devices 3
2.5 Requirements of the electrical installation
by the customer 3
3 Product description 4
3.1 RMZ 4
3.1.1 DIP switch on the RMZ 4
3.1.2 Clamp terminal assignment
of the RMZ 4
3.1.3 Display of the operating status
of the RMZ 4
3.2 EMF 4
3.3 Technical data 4
3.3.1 RMZ 4
3.3.2 EMF 4
4 Installation 5
4.1 Prepare the mounting of the slide rail 5
4.2 Mount the base 5
4.3 Mount the slide rail and RMZ 5
4.4 Mount the door closer 5
4.5 Establish electrical connections 5
5 Start up 5
5.1 Set the DIP switch 5
5.2 Laying the lines 5
5.3 Set the fixture point 6
5.4 Set the release force 6
5.5 Mount the paneling 6
5.6 Check the EMF 6
5.6.1 Release EMF manually 6
5.6.2 Delete EMF electronically 6
5.7 Check the function of the catching device
via the RMZ 6
6 Closing the installation 6
6.1 Acceptance test 7
7 Operating 7
7.1 Open and lock door 7
7.2 Close door 7
8 Maintenance 7
9 Maintenance by dormkaba 7
10 Dismounting, recycling and disposal 7
WN 059420 45532 – 2018-11
To Next Page
Need help?
General
