EN
WN 059722 45532 – 2019-03
System manual
SafeRoute®-System
Mini, Basic und Standard
Contents
1 About this document 2
1.1 Contents and purpose 2
1.2 Target group 2
1.3 Other applicable documents: 2
1.4 Documents storage 2
1.5 Abbreviations 2
1.6 Symbols used 2
1.6.1 Hazard categories 2
1.6.2 More symbols 2
2 Safety 3
2.1 Intended use 3
2.2 General safety instructions 3
2.3 Personnel qualification 3
3 Product description 3
3.1 Parts included 3
3.2 Technical information 3
3.3 Basic components 3
3.3.1 SafeRoute® Control Unit 3
3.3.2 Emergency button with connected key
switch 3
3.3.3 Electrical door lock STV xxx 3
3.3.4 Power supply unit 4
3.3.5 DCW® bus 4
3.4 Extension of the SafeRoute® system 4
3.4.1 Additional DCW® components 4
3.4.2 Inputs and outputs on the SCU 4
3.4.3 RS232 interface at the SCU (available
from Basic license) 4
3.5 Functional scope 4
3.5.1 Release and unlock 4
3.5.2 Relocking 4
3.5.3 Monitoring 4
3.5.4 Visual and audible indicator 4
4 Mounting 5
4.1 Requirements for mounting a SafeRoute®
system 5
4.1.1 Door unit 5
4.1.2 Requirements for fire and smoke
protection doors 5
4.2 Mounting the components 5
4.2.1 DCW® bus addressing (door entry
system) 5
5 Commissioning 5
5.1 Put the SafeRoute® system into operation 5
5.1.1 SCU-UP and SCU-TL as SafeRoute®
Control Unit 5
5.1.1.1 Configure an SCU-UP/SCU-TL 5
5.1.2 SCU-DR as SafeRoute® Control Unit
(from Basic license) 6
5.1.2.1 Configure an SCU-DR 6
5.2 Parameterization with TMS Soft® (from Basic
license) 6
5.3 Handover of the documentation to the facility
operator 6
6 Status query of a configured unit 7
6.1 Querying the status of an SCU-UP/SCU-TL 7
6.2 Querying the status of an SCU-DR 7
7 Troubleshooting 8
7.1 Illuminated ring display in case of alarm and
malfunction 8
8 Replacement and removal of components 11
8.1 Replace non-safety related DCW® components 11
8.2 Remove non-safety related DCW® components
completely 11
8.3 Replace/remove safety-related DCW®
components 11
8.4 Update internal DCW® table 11
8.4 Reset configuration to factory settings 11
9 Maintenance 12
10 Disassembly, recycling and disposal 12
11 Manufacturer's declarations and test
certificates 12
12 Annex 13
To Next Page
Need help?
General
