2
SafeRoute® System
2019-03
WN 059722 45532
dormakaba About this documentSystem manual
1 About this document
1.1 Contents and purpose
This document contains the information and
instructions for the installation and operation of
a SafeRoute® system on an emergency exit door
unit according to EltVTR (12/1997 version) and DIN
EN13637:2015. The functional scope information
refers to a SafeRoute® system with the Standard
license.
1.2 Target group
This document is intended for assembling technicians
and specialists authorized by dormakaba for the
installation, operation, maintenance and testing of a
SafeRoute® system.
1.3 Other applicable documents:
The following documents belong to the unit’s
complete documentation and must be observed:
• The installed individual components’ assembly
instructions and documents
• The operation manual
• The inspection log for the door unit on which the
SafeRoute® system was installed
• The TMS Soft® handbook
• The approved components’ declaration of
conformity
1.4 Documents storage
This document and the other applicable documents
must be handed over to the facility operator after
commissioning. The facility operator must keep
the documents for the entire service life and make
them accessible to the persons responsible for the
inspection and maintenance of the emergency exit
door unit.
1.5 Abbreviations
Abbreviation Definition
SCU-xx
SafeRoute® Control Unit - Control
unit of a SafeRoute® system in three
versions:
• SCU-UP = Flush mounting
• SCU-TL = in the door terminal
STL-G
• SCU-DR = DIN rail mounting
SLI License card
SLI-A Application
STL-G
Door terminal with emergency
button SCU-TL and key switch ST
STV xxx Electrical door lock
ST Key switch
1.6 Symbols used
1.6.1 Hazard categories
WARNING
This signal word indicates a situation of
potential risk, which could lead to death or
serious injury if not averted.
1.6.2 More symbols
TIPS AND RECOMMENDATIONS
This signal word indicates useful information
for efficient and trouble-free operation.
To Next Page
Loading...