2200 Retro Fit Tails for 2100 Conveyors
Dorner Mfg. Corp.
6 851-461 Rev. A
12. With bearing installed in head plate, press bearing
onto non–drive shaft (L of Figure 11).
Figure 11
L
M
13. Install pulley assembly on conveyor. On both
sides of conveyor tighten fastening screws (N of
Figures 12 and 13) to 60 in–lbs (7 Nm).
Figure 12
N
Figure 13
N
B
14. Insert screws (B of Figure 13) into both head
plates. Tighten to 60 in–lbs (7 Nm)
15. With 4mm hex key wrench, tighten pulley taper
screw (E) to 35 in–lbs (4 Nm). Steady pulley with
second hex key wrench (O of Figure 14) inserted
into pulley hole (M of Figure 11).
Figure 14
E
O
16. Install bearing cover (F of Figure 15) into head
plate.
Figure 15
F
17. Install, tension, and track conveyor belt, refer to
manual 851–452, “2200 Series End Drive Con-
veyors.”
Installation
To Next Page
Loading...
