How to fix a damaged motor piston in dosatron D14 MZ 3000 Laboratory Equipment?
If the motor piston in your DOSATRON Laboratory Equipment is damaged, contaminated, or the check valve parts are worn or missing, you should return the unit to your service center for repair or clean/replace the affected parts.
What to do if dosatron D14 MZ 3000 has a blocked suction tube?
If your DOSATRON Laboratory Equipment isn't drawing concentrate and you suspect a blocked suction tube or clogged strainer, clean or replace the affected component.
What to do if motor piston dosatron D14 MZ 3000 Laboratory Equipment does not start?
If the motor piston in your DOSATRON Laboratory Equipment doesn't start, or you notice injection water flowing back into the concentrate container, here's what you can check: * **Piston Stalled:** Try resetting the piston by hand. * **Air in the Unit:** Bleed air from the unit using the bleed button. * **Maximum Flow Exceeded:** 1. Reduce the flow and restart the unit. 2. Unscrew the bell, remove the piston, and inspect the piston valve seals to ensure they are correctly positioned. * **Damaged Motor Piston:** If the motor piston is damaged, contaminated, or the check valve parts are worn or missing, return the unit to your service center for repair, or clean/replace the affected parts.
Why is there no suction of concentrate in my dosatron D14 MZ 3000?
If your DOSATRON Laboratory Equipment is not drawing concentrate, consider these potential causes and solutions: * **Piston Motor Stopped:** Refer to the Motor Piston section for troubleshooting. * **Air Leak (Inlet):** Check the tightness between the nut and suction hose to eliminate any air leaks. * **Blocked Suction Tube or Clogged Strainer:** Clean or replace the suction tube or strainer if they are blocked. * **Missing or Worn Components:** Clean or replace the suction check valve seal or plunger seal if they are missing or worn. * **Worn Injection Stem:** Replace the injection stem if it is worn.
General safety and operational guidelines for installing the Dosatron unit, covering common risks and best practices.
Step-by-step instructions for physically assembling the Dosatron unit and its mounting bracket.
A step-by-step guide for the initial setup, priming, and first-time operation of the Dosatron.
Guides users through diagnosing and fixing various types of leaks occurring in the Dosatron unit.
General| Model | D14 MZ 3000 |
|---|---|
| Category | Laboratory Equipment |
| Injection Type | Proportional |
| Flow Rate | 3000 L/h |
| Maximum Flow Rate | 3, 000 L/h |
| Dosing Range | 0.03% to 0.3% |
| Pressure Range | 0.3 to 6 bar |
| Operating Pressure | 0.3 to 6 bar |
| Pressure | 0.3 to 6 bar |
| Temperature Range | 5°C to 40°C |
| Materials | Polypropylene, EPDM |
| Material | Polypropylene, EPDM |
| Connection Size | 3/4" NPT |
| Power Supply | Hydraulic |
| Dimensions | 150 mm |
To Next Page
