23 Instruction manual
Troubleshooting
Error message What to do
40 - Apply Delay too
short
Raise the application time in the Setup menu. It
should be longer than the print time.
42 - Barcode error The barcode reader needs to be adjusted or the
print quality needs to be improved.
50 - Paper Out Insert a new roll of paper. Make sure that the roll is
positioned properly.
51 - Ribbon Out Insert a new roll of ribbon. Make sure that the roll is
positioned properly.
60 - No Label on Grid Check whether:
1. The label has fallen or is too short to be detected.
2. The label is outfed.
61 - Label on Grid Check whether:
1. A label has already been placed on the pad of the
applicator.
2. The sensor is dirty.
63 - Arm Not Home Something is preventing the applicator arm from
reaching its resting position. Check whether:
1. The applicator arm is bent.
2. The resting sensor is operating.
70 - Head Lifted Lower the print head lever.
Check whether the microswitch is defective then
recalibrate the printer.
71 - Cover Open Close the cover.
72 - Overheated Check the cooling fans.
Make sure that the ambient temperature is correct.
75 - No Air Pressure Check the air lever and the air connections.
Check the pressure sensor; adjust it if necessary.
Check the air control.
For other errors, please contact Markem-Imaje support.
To Next Page
Loading...
