To Next PageTo Next Page
Need help?Do you have a question about the Dover Vitronics Soltec DeltaWave 6622cc and is the answer not in the manual?
General| Brand | Dover |
|---|---|
| Model | Vitronics Soltec DeltaWave 6622cc |
| Category | Industrial Equipment |
| Language | English |
Explains packaging symbols for safe handling and transport.
Provides machine dimensions and weight for empty and filled states.
Illustrates the center of gravity for the palletized machine.
Details the procedure for safely unpacking the machine from its crate.
Guides on how to lift and move the machine using a forklift.
Instructions on adjusting the machine's leveling pads for stability.
Specifies the maximum weight each leveling pad can support.
Details required clearance around the machine for operation and maintenance.
Refers to the installation sheet for detailed requirements.
Guidance on placing the machine in its designated location.
Steps for setting the machine's attitude and leveling.
Procedures for safely connecting the machine to electrical power.
Instructions for connecting the compressed air supply.
Steps for connecting the nitrogen supply (when installed).
Information on connecting and using the exhaust system for fume extraction.
Instructions for setting up the personal computer for machine control.
Methods for filling the solderpot with solder material.
Procedures for qualified personnel before starting the machine.
Steps to test sensors and verify machine functions after startup.
Checklist of essential items before initiating the start process.
Step-by-step guide for powering on and starting the machine.
Procedure for restarting the machine after a stop.
Ensuring the machine is empty before initiating shutdown.
Manual procedures for stopping the machine operation.
Steps to completely turn off the machine.
Procedure for restarting the machine after an emergency stop.
Adjusting the solderwave nozzle for optimal performance.
Adjusting the backplate to control solder overflow.
Setting the chipwave for proper solder application.
Adjusting the sensor for the correct solder level in the bath.
Instructions for setting up and operating the foamfluxer.
Procedures for setting up and operating the spray drumfluxer.
Steps for setting up and operating the nozzlefluxer.
Instructions for setting up and calibrating the flux density control unit.
