I
NSTALLATION
8
C
HAPTER
1
1.3.6 E
LECTRICAL
CONNECTION
Only qualified electricians should work on the electrical circuits of the machine.
1. Feed the mains-cable for the whole machine trough the top side of the infeed section.
2. Connect the mains leads in accordance with the diagrams.
Check the current rotation of the phases. The current rotation of the phases L1, L2, L3 must be
clockwise.
3. Block the mainswitch with a padlock to prevent dangerous situations.
1.3.7 A
IR
CONNECTION
1. Connect the air supply hose to the 10 mm hose spigot at the rear infeed side of the machine.
Make sure that the supplied air is free of oil and moisture.
1.3.8 N
ITROGEN
CONNECTION
When nitrowave installed only.
1. Connect the nitrogen supply hose to the 10 mm hose spigot at the rear outfeed side of the
machine.
To Next Page
Loading...
