17
USING THE DPA ADAPTERS
All DPA 4099 clip microphone cables are terminated with a
proprietary MicroDot connector. When used in conjunction with
our range of over 35 adapters, the MicroDot connector provides
the ability to connect to virtually all available pro wireless systems.
Various wireless systems require the use of electronics inside the
adapter to optimize the signal level, the DC offset, and power-
ing of the built-in microphone preamplifier. Using the adapters
from DPA ensures the correct electronic circuit with the listed
types of wireless systems (please visit www.dpamicrophones.com/
adapters).
The enclosed XLR adapter allows the 4099 to work as a regu-
lar 48V phantom powered microphone. The belt clip can be
removed and replaced with the enclosed ring for use of the
adapter directly in stage boxes or mixing consoles. Dismount the
cap of the adapter, remove the belt clip and place the black ring
instead. Remount the cap.
Do not attempt to employ non-standard adapters or connectors
as you might damage the microphone.
A connector-tightening tool is supplied with each adapter and
should be employed whenever the MicroDot connector needs
to be tightened. Utilize the tightening tool before use to ensure
the connection is secure and that the cable cannot rotate by
the cable relief.
Enclosed adapter
DAD6001-BC
DPA 4099B
DPA 4099C
DPA 4099D
DPA 4099P
DPA 4099U
DAD4099
DPA 4099G
DPA 4099S
DPA 4099T
DPA 4099V
To Next Page
Loading...
