To Next PageTo Next Page
Need help?Do you have a question about the D+H KA Series and is the answer not in the manual?
Read all safety warnings, instructions, illustrations and specifications provided with this product.
Chain drive for electric opening and closing of windows and flaps in the facade and roof area.
Safety extra low voltage 24 V DC! Do not connect directly to the mains supply!
ACB bus interface with ModBus protocol for connection to compatible D+H control panels.
Drive unit with 2,5 m silicone cable. Different bracket sets are available separately.
Observe maximum pressure load of the chain! Maximum pressure load of the chain is not automatically identical.
Specifies opening and closing stroke lengths and forces for different models.
Describes active and passive protection for the main closing edge during operation.
Drives require reconfiguration via SCS software after alterations like adding or removing drives.
Forces must be rearranged by SCS software for vertical active pulling applications.
For IP 42 option, the chain outlet must not point upwards.
Null balance with SCS software is necessary if measure x is >= 23 mm.
Used for secure communication between drive and D+H control systems via Modbus RTU protocol.
Allows up to 8 drives to communicate via bus, with one main drive controlling others.
Check for correct main drive identification and ensure proper wiring.
Requires SCS software and BSY+ interface for further troubleshooting or configuration.
Only authorized personnel should perform maintenance using original D+H spare parts.
Wipe away debris with a dry, soft cloth. Do not use cleaning agents or solvents.
Details pin assignment for motor, ACB, and BSY+ connections.
Wiring diagram for Modbus RTU server and client configurations.
Provides a diagram with key dimensions H, A, and B for different model variants.
Lists specific H, A, and B values for various stroke lengths.
General