RED and YELLOW flashing LEDs indicate an error occurred with your device. Upon the SWITCH entering the
RED and YELLOW flashing sequence, turn the device off by returning the power SWITCH to the center
position and follow the directions below.
Reset the device by rotating and removing the magnetic base plate from the bottom of the SWITCH. Once the
base plate is removed, position the retainer clips out of the battery’s path to pull out the battery pack. Keep the
battery pack removed for 10 seconds.
After 10 seconds, put the battery back into the device and reposition the retainer clips. Replace the base plate
and turn the unit back on. The unit should go back to normal functionality. If the LED display continues the
flashing sequence contact the Dr. Dabber Customer Service Team for further assistance.
Support Line: 1 (855) 362-3227 (#) Support Email: support@drdabber.com
For helpful tips and trick as well as all the latest accessories, head over to www.drdabber.com
(http://www.drdabber.com)
To Next Page
Loading...
