3. Retighten the stem’s lock nut counter-clockwise to lock it in place.
Adjusting the search coil
1. Loosen the knobs at the search coil and rotate the coil angle until it
is parallel with the ground.
2. Tighten the knobs just enough to prevent the search coil from
rotating or wobbling.
Installation of battery
1. Loosen the screw with a screwdriver, then remove the battery
compartment cover.
2. Please use a 9 volt battery. Insert the battery into the
compartment in the same direction as indicated by the marks.
Operation
1. Raise the LCD ⑤.
2. Push the power switch ① to turn on the detector. At this time,
To Next Page
Loading...
