DR PILOT 2 - Page 26

26 DR
®
PILOT 2 Cycle Tiller/Cultivator
Parts List and Schematic Diagram - Tines and Hood Assembly
NOTE: Part numbers listed are available through DR Power Equipment.
Ref# Part# Description
1 26128 Hair Pin, 5/8-3/4 Inch Cotter
2
26114 Tine “A” Right Outside
3
26116 Tine “B” Right Inside
4
39967 Nut M8 Nylock
5
26146 Washer M8 Curved
6
39908 Transmission Assembly
7
26143 Bolt M8 X 1.25 X 155 Hex Flange
8
26115 Tine “C” Left Inside
9
26117 Tine “D” Left Outside
10 26134 Bolt M10 X 1.5 X 231 Hex Flange
11 26112 Washer M10 Narrow Flat
12 39968 Wheel 180 X 38 mm Diamond Tread
Grey Hub
13 26131 Guide Wheel Tube
14 39969 Handlebar Lower
15 26125 Nut M10 X 1.5 Center Lock Hex
16 26130 Wheel Tube
17 39970 Pin Lock 8mm X 40mm
Ref# Part# Description
18 26127 Nut M6 Nylock
19 39971 Washer M6 X 13 X 1.75 Flat
20 26129 Wheel Holder
21 26113 Drag Stake
22 39972 Bolt M5 X 0.8 X 10 Hex Flange
23 39973 Tine Shield
24 39974 Nut M5 X 0.8 Nylock Flange
25 26124 Bolt M6 X 1.0 X 42 Hex Flange
26 26132 Tube Wheel Lock
27 26133 Spring Wheel Lock
28 13230 Washer 21 X 16 X 1 mm
29 46142 Bolt M6 X 1.0 X 15 Hex Flange
30 23433 Engine Mc43
Not Illustrated:
39928 Label, Controls, Tine Engage
39929 Label, Warning, Keep away from
rotating tines
39930 Label, Operation, Place Free Hand Here