DR PILOT 4 User Manual

CONTACT US AT www.DRpower.com 11
 Make sure the unit is in a stable position before pulling the starter handle.
 When the unit starts to fire or run, return both hands to the handlebar position to maintain control and stability of
the unit.
 Starter rope can cause an unanticipated jerk towards engine. Please follow instructions to avoid injury.
 Never leave engine running while unattended. Turn off after every use.
 Never carry Tiller from one location to another while engine is running.
 Always wear a protective hearing device.
 Do not start engine if fuel is spilled. Wipe off excess fuel and allow to dry.
DO NOT attempt to start engine in the following ways:
 DO NOT use starting fluid.
 DO NOT spray flammable liquids or vapors into air cleaner, carburetor or spark plug chamber.
 DO NOT remove spark plug and attempt to start engine. Flammable fuel can spray out & ignite from a spark from
spark plug.
Chapter 3: Operating Your DR PILOT 4 Cycle Tiller/Cultivator
Operation Tips
 The clutch will transfer maximum power after about two hours of normal operation. During this break-in period
clutch slippage may occur. The clutch should be kept free of oil and other moisture for efficient operation.
 Cultivate without placing excessive body weight on the unit. The Tiller/Cultivator operates most efficiently with the
weight of the unit itself.
 Never run engine indoors. Exhaust fumes are deadly.
 Do not spray water on or near the electronics of the Tiller/Cultivator as this may result in damage to the electrical
components.
 For cold weather operation, store the unit in a cool environment. Transferring the unit from a cold to a warm place
can cause the build up of harmful condensation.
Starting and Stopping Engine
Note: If engine fails to start after following starting procedures, please contact us at www.DRpower.com or call 1-800-DR-
OWNER (376-9637) for assistance.
 Move engine to a well ventilated area, outdoors, to prevent carbon monoxide poisoning.
 Move to an area away from flames or sparks, to avoid ignition of vapors if present.
 Remove all debris from air cleaner holes and gas cap
to ensure proper air flow.
 If it is the first time starting the Tiller/Cultivator,
make sure the 4-cycle oil has been poured into the oil
fill area to the correct level.
COLD ENGINE START:
Starting engine for first time or after engine has cooled
off or after running out of fuel.
1. Move choke lever to CHOKE position (Figure 6).
Note: CHOKE position is defined by moving the choke lever
as far to the right, towards gas tank, as possible.
2. Prime unit by pushing the primer bulb until primer
hose is filled with gas.
Figure 6

DR PILOT 4 Specifications

General

Brand	DR
Model	PILOT 4
Category	Tiller
Language	English