Dräger Aerotest Simultan HP

Other manuals for Dräger Aerotest Simultan HP

Questions and Answers

C
Christian DanielAug 9, 2025
What to do if there is a major measurement fault with Dräger Aerotest Simultan HP Test Equipment?
- K
  Karen EdwardsAug 9, 2025
  If you're experiencing a major measurement fault with your Dräger Test Equipment, several factors could be the cause. First, verify that the tube is inserted in the correct holder. Additionally, the tube holder might be dirty or loose, so try cleaning or replacing it. Finally, a blocked feed system can cause the wrong volumetric flow. To resolve this, unscrew the tube holder from the measuring unit and use compressed air to clear the feed insert from both sides.
S
Sherry WilliamsAug 15, 2025
Why is the pressure reducer leaking on my Dräger Test Equipment?
- J
  Jose KellyAug 15, 2025
  If the pressure reducer on your Dräger Test Equipment is leaking, it's likely due to the safety valve blowing off. In this case, it is recommended to have the pressure reducer repaired.
D
dmorrisonAug 20, 2025
How to fix a leaky compressed air connection on Dräger Test Equipment?
- W
  William RichardsonAug 21, 2025
  If you notice a leaky compressed air connection on your Dräger Test Equipment, the cause may be a defective sealing ring. You should check the sealing ring and replace it if necessary.
K
Kimberly GlassAug 27, 2025
What to do if the tube is not firmly seated in the tube holder of Dräger Aerotest Simultan HP?
- P
  Paul MartinAug 27, 2025
  If the tube is not firmly seated in the tube holder of your Dräger Test Equipment, it's probably because the tube holder is worn. The suggested solution is to replace the tube holder.
T
tylercooperSep 2, 2025
Why is the tube end not cleanly scratch marked and broken off on my Dräger Aerotest Simultan HP?
- N
  Nancy WrightSep 2, 2025
  If the tube end is not cleanly scratch marked and broken off on your Dräger Test Equipment, the tube opener is likely blunt. Replace the tube opener to resolve this issue.