Dräger Alcotest 7510 - Print the Result Protocol; Printout of Saved Test Results

54
Print the result protocol
Print the result protocol
The Alcotest 7510 can exchange data with the "Dräger Mobile Printer" and print a result proto-
col using the infrared interface see “Data interface” on page 53) . Protocol content is based
on the configuration, e.g., measurement result, device information, subject data and user data.
Printout of saved test results
● To print saved test results, access the menu item » Show last tests « (see Main menu /
Menu information, page 39), and select the corresponding test.
— Continue the procedure as per the procedure directly after a measuring sequence
● When the printout is finished, exit the menu or select an additional test, as applicable.
Printout procedure upon completion of a
measuring sequence:
● Switch on the "Dräger Mobile Printer" as
per the Dräger Mobile Printer Instructions
for Use.
● When the Dräger Alcotest 7510 shows
the test result, place the device next to the
Dräger Mobile Printer so that the infrared
interfaces (IR) directly face each other.
— The printing of the protocol automatically
starts. The number of printouts corre-
sponds to the device configuration.
— If the printout is interrupted during the
printing process by a disconnection of
the visual communication of the interfac-
es, the printout will be completely restart-
ed after the visual communication has
been restored.
● When the printout is finished, press the
key to start a new measurement.
D
Alcotest 7510
OK
IR
00423997_01.eps
OK