Dräger Babylog 8000 plus - Configuring Data Interfaces

Instructions for use Babylog 8000 plus SW 5.n 101
Configuration
Selecting the language
The device is factory set to the customer's
language.
1 Open the dialog window by pressing the Cal.
Config. > Config > Lang keys.
The selected language is highlighted.
2 Use the and keys to select the
language.
This setting is saved after the device is switched
off.
Configuring the data interfaces
The following data interfaces can be configured:
– Analog output ports
– Impulse output
–RS232
This setting is saved after the device is switched
off.
Selecting the measuring signals and
scale range for the analog output ports
1 Open the dialog window by pressing the Cal.
Config. > Config > Com keys.
2 Press the Param key repeatedly until Analog1
is highlighted.
3 Use the and keys to select the
measuring signal.
4 Press the Param key.
5 Use the and keys to select the
scale value.
Select the settings for Analog2 in the same way.
2111921151