Instructions for use Babylog 8000 plus SW 5.n 73
Operation
Performing pneumatic medication
nebulization
Conditions:
– Medical gas supply from the central gas supply
system or compressed gas cylinders must be
ensured.
– The kit for medication nebulization 8411025 is
available.
– The medication nebulizer 8411030 has been
prepared in accordance with the corresponding
instructions for use.
– The flow sensor must be removed from the
breathing circuit, see page 71.
Mounting the coupling
1 On the left side of the device, unscrew the
bottom mounting screw on the housing with a
coin.
2 Screw the coupling (A) into place with the
mounting screw.
3 Insert the plug (B) into the socket on the rear of
the device until it locks in place.
Installing the pneumatic medication nebulizer
1 Remove the corrugated hose of the breathing
circuit (C) from the inspiratory port of the Y-
piece and connect it to the inlet port of the
medication nebulizer.
2 Connect the corrugated hose (D), length
0.13 m (5.1 in), to the outlet port of the
medication nebulizer.
3 Connect the free end of the corrugated hose
(D) to the inspiratory port of the Y-piece.
When used on the incubator:
Push the inlet port or the outlet port of the
medication nebulizer into the upper hose guide
of the incubator.
21183
2118421185
To Next Page
Loading...
