Dräger Babylog 8000 plus - Suppressing and Reactivating Alarms; Acknowledging Alarm Messages

Instructions for use Babylog 8000 plus SW 5.n 83
Alarms
Suppressing the acoustic alarm signal
The acoustic alarm signal can be suppressed for a
maximum of 2 minutes.
If another alarm occurs during this time, no alarm
signal sounds. However, the alarm message is
displayed on the screen.
If the fault triggering the alarm is not resolved after
2 minutes, the alarm signal sounds again.
 Press the key.
The yellow LED on the key lights up.
Early reactivation of the alarm signal
 Press the key.
The yellow LED on the key goes out.
Acknowledging alarm messages
After the fault triggering the alarm has been
resolved, the alarm tone is silenced. High-priority
alarm messages continue to be displayed and
need to be acknowledged.
 Press the OK key.