Instructions for use Babylog 8000 plus SW 5.n 93
Monitoring
Information on monitoring
Sensors and calibration intervals
The device uses the following sensors for
measurement and monitoring:
Recalibration is not necessary if the flow sensor
has been unplugged only briefly.
Sensor Calibration
Pressure sen-
sor
Automatic calibration
O2 sensor Automatic calibration every
24 hours
Manual calibration after replace-
ment
Flow sensor Manual calibration:
– After switching on
– After reprocessing
– After replacement
CAUTION
Device function impaired
If the sensors are not calibrated, device function
may be impaired.
Calibrate the sensors at the indicated intervals.
To Next Page
Loading...
