Dräger caleo - Page 42

Preparation
42
Operating Instructions Caleo, Software 2.n
Use of Doors, Ports, and Bed Adjusting Mechanism
Double wall*
The double wall (2M 51 150) can only be fastened to the
canopy (2M 51 108)!
Fitting the double wall:
1 Pull the pin up as far as it will go.
The red section of the pin must be visible.
z Carefully place the double wall on the hood.
2 Position the centring sleeve lugs in the recesses of the
hood.
3 Place the bore sleeve of the double wall assembly in the
hole for the "feeding grommet" plug.
z Take care to assure a snug fit of the double wall seal with
the contour of the hood.
Securing the double wall:
4 Push the pin down into the sleeve until it engages.
The red section of the pin must no longer be visible.
* Available option
270
1
271
2
2
3
282
4