What to do if the % O2 LOW alarm appears on my Dräger Medical Equipment?
If the inspiratory O2 concentration is below the lower alarm limit, check the O2 supply and the setting on the O2 flow meter.
What to do if PAW HIGH alarm appears on my Dräger Cato?
If the airway pressure exceeds the upper alarm limit, immediately check the patient's condition!
How to fix % HAL HIGH alarm on Dräger Cato?
If the inspiratory anaesthetic concentration exceeds the upper alarm limit, check the setting of the anaesthetic vaporizer.
What should I do if the APNOEA CO2 alarm appears on my Dräger Cato?
If ventilation is at a standstill and no breath is detected by expiratory CO2 for 30 seconds, the patient must immediately be ventilated by hand!
What should I do if the APNOEA PRES alarm appears on my Dräger Cato Medical Equipment?
If ventilation is at a standstill, the patient must immediately be ventilated by hand!
What should I do if the APNOEA VOL alarm appears on my Dräger Medical Equipment?
If ventilation is at a standstill and there is no expiratory tidal volume for 15 seconds (30 seconds for SIMV alarm limits), the patient must immediately be ventilated by hand!
How to resolve AW-TEMP HIGH alarm on Dräger Cato Medical Equipment?
If the inspiratory breathing gas temperature is over 40 °C, disconnect the breathing gas humidifier and set a lower heating level when the temperature has dropped to 37 °C.
What causes the % O2 HIGH alarm on Dräger Cato and how do I fix it?
If the inspiratory O2 concentration exceeds the upper alarm limit, check the O2 concentration in the fresh gas.
What to do if the % HAL LOW alarm appears on my Dräger Cato Medical Equipment?
If the applicable inspiratory anaesthetic concentration is below the lower alarm limit, check the setting of the anaesthetic vaporizer.
How do I troubleshoot the MIN VOL HIGH alarm on my Dräger Medical Equipment?
If the minute volume exceeds the upper alarm limit, correct the tidal volume or respiration rate on the ventilator.
General| Type | Anesthesia Workstation |
|---|---|
| Tidal Volume Range | 20 to 1400 ml |
| PEEP | 0 to 20 cmH2O |
| Gas Supply | O2, N2O, Air |
| Integrated Monitoring | Yes |
| Power Supply | 100 - 240 V AC, 50/60 Hz |
| Usage | Operating Room |
| Ventilation Modes | Volume Controlled |
| Vaporizer Mounts | Up to 2 |
| Alarms | Gas Supply Failure |
To Next Page