Dräger Cato - Ippv; Selecting IPPV Mode; Adjusting Ventilation Parameters

IPPV
Selecting IPPV mode
Secretion aspirator may only be used in
»MAN/SPONT« mode or with disconnected
Y-piece.
After switching on, the ventilation parameters set prior to
delivery or subsequently programmed by DrägerService
are active in IPPV mode.
1 Set the values required for the patient.
Default settings upon delivery of new equipment:
(may be altered by DrägerService if requested by
customer)
VT Tidal volume 0.6 L
fIPPV IPPV frequency 12 breaths/min.
Pmax Maximum ventilation pressure 25 mbar
TI:TE Inspiration/expiration time ratio 1 : 1.7
TIP:TI Inspiration pause/inspiration
time ratio 10 %
2 Set PEEP – if necessary.
3 Press »IPPV«.
4 Display in dialogue field:
IPPV Mode ?
5 Press rotary control to confirm –
ventilation starts.
The parameters Pmax, VT, fIPPV, PEEP and piston
movement are displayed on the ventilator.
The monitor is also started and the IPPV alarm limits
are activated.
Adjusting ventilation parameters (Pmax for example):
6 Press »Pmax«.
1 The set value appears in the window above, while
4 the set value (left), the parameter and its unit of
measure (middle) and the value to be adjusted (right)
appear in the dialogue window.
5 Turn rotary control:
4 the value on the right changes –
5 continue turning until the required maximum pressure
is reached. Press rotary control to confirm this value –
1 the new value is displayed –
if the new value is not confirmed, it will not be
adopted by the system and the display disappears
after approx. 10 seconds.
● fIPPV, VT, TI:TE, TIP:TI, PEEP and fIMV are adjusted
like Pmax after pressing the corresponding parameter
key.
39
Operation
IPPV
Selecting IPPV mode
1
2
3
4
5
alarm
limits
auto set
vent. al.
curve
list
config.
alarm
info
IPPV alarm limits
SpO
2
98 67
etCO
2
38
MV 6.0 freq 10
Fi Fet
O
2
29 25
Hal. 0.8 0.6
N
2
O 70 68
CO
2
40
0
PAW
20
0
20
18
1
6
4
5
[
02028971 0712897007328970