Preparation
48
Operating Instructions Caleo, Software 2.n
Use of Doors, Ports, and Bed Adjusting Mechanism
Tilting the bed
To tilt the bed:
z Switch Caleo ON (see page 64).
1 Press button and the bed will be lowered on the sensor
unit side.
2 Press button and the bed will be raised on the sensor unit
side.
z Adjust the bed to the required tilt angle.
When the tilt angle stops changing, the end position has been
reached. Release button.
NOTE: The entire Caleo bassinet is tilted.
NOTE: Adjustment of height and tilt angle cannot be performed
at the same time.
Adjusting the bed to the horizontal position
z Caleo must be switched on (see page 64).
1 Press button to raise bed on the control unit side.
2 Press button to lower bed on the control unit side.
The levels will indicate whether the bed is horizontal.
3 Level showing the horizontal position of Caleo in the
transverse axis.
4 Level showing the horizontal position of Caleo in the
longitudinal axis. When using the integrated infant scale
(available option, see "Integrated Infant Scale", page 112),
make sure that the incubator unit is on a level floor before
making adjustments.
WARNING !
Do not reach between incubator housing and housing
support while tilting the bassinet. Risk of injury!
CAUTION !
Cables and hoses must be carefully routed to avoid kinking,
tear or pinching when adjusting the incubator tilt angle!
To Next Page
Loading...
