D-39523-2015
Disassembly
Loosen the three screws of the
ventilator with a hexagon key.
Tighten the three screws of the
ventilator with a hexagon key.
Pull the breathing system up
and out by the handle.
Use the handle to insert
the breathing system into
the mounting fixture.
Insert the cleaning disk into
the adapter. Close the adapter
until it clicks into place.
Remove the CLIC CO
2
absorber.
Unscrew the CLIC adapter
(optional).
Loosen the five screws of the
breathing system with a screw-
driver and remove the cover.
Place the cover on the breathing
system and tighten the five
screws with a screwdriver.
Remove both flow sensors.
Lift up the middle part
of the breathing system.
Assembly
Insert the ventilator diaphragm
so that the Dräger inscription
is visible from above.
Remove the upper ventilator
diaphragm.
Loosen the inspiration and
expiration nozzles and pull
them off.
91 02 536 | 16.08-1 | HQ | PP | Subject to modifications | © 2016 Drägerwerk AG & Co. KGaA
Insert both flow sensors.
Put on the inspiration nozzle
and expiration nozzle and
turn to tighten.
Screw on the CLIC adapter
(optional). Insert the CLIC CO
2
absorber.
Remove cleaning disk from
the adapter. Close the adapter
so that it can click into place.
Place the middle part of the
breathing system on the bottom
part of the housing.
Primus® Family*
Breathing System
Disassembly/Assembly
90°
90°
* Primus Infinity Empowered, Primus, Pallas, Apollo
90°
90°
To Next Page
Need help?
General
