What to do if gas monitors don't pass gas tests on Dräger Test Equipment?
If gas monitors fail gas tests because the test gas isn't reaching the instrument, first verify that all hose connections are correct. Then, check the gas configuration. Also, ensure that the test gas cylinder is not empty or closed, and verify the pressure regulator valve setting.
How to troubleshoot a Dräger X-dock 6300 Test Equipment station that does not start?
If your Dräger Test Equipment station doesn't start, check the connections to the mains supply, power pack, and the station itself. If the connections are correct, the power pack might be defective and need replacement. Also, verify that the station can be started by pressing the function key.
Why is my Dräger Test Equipment not communicating with my PC?
If the Dräger Test Equipment isn't communicating with your PC, start by checking the cabling of the Ethernet cable. If the cable is correctly connected, try replacing it. If the issue persists, reconfigure the IP address and ensure the firewall isn't blocking data traffic. If your network uses the IP address 192.168.79.XXX, this may cause issues, so try another address range.
What to do if the Dräger Test Equipment touchscreen is not working properly?
If the Dräger Test Equipment's touchscreen is not working correctly, it may need recalibration. Recalibrate the touchscreen.
Why doesn't Dräger X-dock 6300 recognize my USB storage device?
If the Dräger Test Equipment doesn't recognize the connected USB storage device, Dräger recommends using FAT32 and a partitioning that contains partitioning tables (USB-ZIP or USB-HDD).
How to fix 'Firmware version not supported on module: X' error on Dräger X-dock 6300?
General| Protection Class | IP 20 |
|---|---|
| Device type | Automatic test and calibration station |
| Number of modules | Up to 6 |
| Power supply | 100 – 240 VAC, 50 – 60 Hz |
| Storage temperature | -20 to 60 °C |
| Interface | Ethernet, USB |
| Supported Devices | Dräger portable gas detection devices |
| Relative Humidity | 10 to 95 % RH, non-condensing |
To Next Page
