Dräger X-dock User Manual

Dräger X-dock
Frequently Asked Questions
Can I use the system also as a “mobile” system?
The system supports 12 V operation, e. g. via the cigarette lighter of a car.
HOME
 
The individual mode is the ideal mode for almost all applications. This is why it is
pre-set. In the individual mode the selected and configured test simply starts by
closing the flap. This mode is only available in logged-out condition.
In a workshop, however, it can occur that different tests are to be carried out.
To do this, the individual mode can be deactivated in the menu. Afterwards three
soft keys are available in the logged-out condition via which the respective test
can be started. It is your choice!
MISCELLANEOUS What exactly is the individual mode option?
Certainly. However, the use of Dräger test gas cylinders facilitates the
configuration: By entering the part-numbers all concentrations are automatically
set immediately. Gas balancing is also only supported for Dräger test gas
cyinders.
Can I also use gas cylinders of other manufacturers?
The Dräger X-dock also supports your existing gas detection instruments.
However, these must be updated to a compatible software version
(Firmware update).
To do this, we offer a CC Vision free of charge which will support you.
Are only new gas detection instruments supported or can I also use my existing ones?
9094227_X-dock_FAQs_210x297_ENGL_5 20.11.13 12:10 Seite 11

Dräger X-dock Specifications

General

Power Supply	100 – 240 VAC, 50 – 60 Hz
Humidity	10 to 95 % RH, non-condensing
Data Storage	Internal memory for device data, calibration data, and test results
Interface	USB, Ethernet
Device Type	Automated test and calibration station
Calibration	Automatic calibration
Bump Test	Automatic bump test
Supported Gases	Depends on the gas detector being tested (e.g., H2S, CO, O2, LEL)
Compatibility	Compatible with Dräger portable gas detectors