To Next PageTo Next Page
Need help?Do you have a question about the Dräger X-AM 5000 and is the answer not in the manual?
General| Ingress Protection | IP67 |
|---|---|
| Operating Humidity | 10 to 95% RH, non-condensing |
| Detection Principle | Electrochemical, Catalytic, Infrared |
| Gases Detected | O2, CO, H2S, NO2, SO2, H2 |
| Number of Gases | Up to 5 |
| Display | Graphical LCD with backlight |
| Alarm Indicators | Audible, visual, and vibration alarms |
| Operating Temperature | -20 °C to +50 °C |
| Data Logging | Yes |
| Certifications | ATEX, IECEx, CSA |
| Response Time | T90 < 15 seconds (sensor dependent) |
Guidelines for using the device in explosion-hazard areas and safety symbols.
Portable gas detection for ambient air monitoring in working and hazardous areas.
Details on classified hazardous areas (zones/divisions) and conditions of use.
Procedure for powering on the device and initial self-test sequence.
Mandatory checks including display, calibration, and alarm elements before use.
Steps for preparing, performing, and checking bump test results with test gas.
Procedure to activate, perform, and confirm fresh air calibration for zero point adjustment.
Steps for selectively adjusting the sensitivity of individual sensors.
Warnings and cautions regarding ignition risk, battery handling, and daily sensitivity testing.
