Draper 10.8V - 8. SETTING THE CORDLESS RECIPROCATING SAW; 8.1 BLADE INSTALLATION

11
8. SETTING THE CORDLESS RECIPROCATING SAW
FIG.1
FIG.2
8.1 BLADE INSTALLATION - FIGS. 1 - 2
Turn and hold the spring-loaded blade release
clamp  counter-clockwise.
Insert the blade into the slot of blade clamp
.
Release the blade clamp to lock the blade.
Check that the blade is secure before operating
the saw.
WARNING: When changing a blade immediately
after operation, allow the blade to cool before
removing to avoid possible burning.

