Draper 32329 - WARM STARTING THE ENGINE; STOPPING THE ENGINE

9.2 WARM STARTING THE ENGINE –
FIGS. 20 – 21
Slide the START/STOP switch  to the START
position.
Note: When starting a warm engine, there is no
need to prime the engine and the choke lever
should be left in the open (on) position.
9.3 STOPPING THE ENGINE – FIG. 22
Slide the START/STOP switch  to the STOP
position.
Put your foot on the frame to help steady the
machine.
Pull the starter cord until the engine fires – it
should take only a few pulls.
– If the engine does not start, refer to the steps
highlighted in the previous section: 9.1 Cold
Starting the Engine.
- 15 -
9. OPERATING INSTRUCTIONS
1
1
2
3
Fig.20

1
Fig.22

1
Fig.21 Fig.5
2
3
