What to do if my Draper PW2000 has no power?
If your Draper Pressure Washer isn't powering on, there are several potential causes. First, the pump might be stuck; in this case, turn the motor manually. Second, the thermal overload may have tripped; switch the unit off and allow it to cool down. Also check the power supply fuse and replace it if it's blown.
Why is my Draper Pressure Washer pump not producing full power?
If your Draper Pressure Washer pump isn't delivering full power, several factors could be responsible. Start by checking the water inlet filter and clean it if blocked. Then, inspect all connections and hoses for air leaks, ensuring they are tightly locked. Furthermore, the suction/delivery valves might be clogged or worn out, requiring cleaning or replacement. Another potential issue is a stuck unloader valve; try loosening and retightening the regulation server. Finally, examine the lance nozzle for any damage or incorrect fitting and replace or correct as necessary.
How to fix fluctuating pressure on my Draper PW2000 Pressure Washer?
If your Draper Pressure Washer exhibits fluctuating pressure, consider these possible causes and solutions: * The pump might be sucking in air. Ensure all hoses and connections are airtight. * Valves could be dirty, worn out, or stuck. Clean or replace them as needed. * Worn out sealing. Check and replace.
What to do if the motor of my Draper PW2000 stops suddenly?
If the motor of your Draper Pressure Washer stops suddenly, it's likely that the thermal safety overload switch has tripped due to overheating. To resolve this, switch the unit off and let it cool for 5-10 minutes.
Why is water leaking from the pump of my Draper PW2000 Pressure Washer?
If water is leaking from the pump of your Draper Pressure Washer, the sealing might be worn out. Check the sealing and replace it.
General| Brand | Draper |
|---|---|
| Model | PW2000 |
| Category | Pressure Washer |
| Language | English |
To Next Page
