Draper PW2000 - Operation (PW2000 and PW2110)

OPERATION
- 10 -
PW2000, PW2110 AND PW2121
HIGH PRESSURE CLEANING
The output water pressure is preset and cannot be
adjusted, the maximum pressure produced is 100
bar (for PW2000), 110 bar (for PW2110). Draper
Tools recommends that before carrying out any
cleaning operations always test a small
inconspicuous part of the area to be cleaned to
check that it is suitable.
The spray lance nozzle is adjustable and can
produce either a powerful fine pencil jet of water
or a less powerful fan jet of water See Figs.11 &
12.
1. To operate the machine switch the machine on
See Fig.13.
2. Aim the lance spray nozzle in the required
direction See Fig.14.
3. Pull the trigger on the handle. The water will
now spray from the lance. Adjust to the type of
spray pattern required as described above. To
stop spraying release the trigger.
FITTING AND USING THE DETERGENT
SPRAYING ATTACHMENTS
1. Detach the lance nozzle assembly $ Fig.2 from
the handle assembly %.
2. From the loose parts supplied with the pressure
washer locate the detergent spraying
attachment - Fig.15.
Fig.14.
Fig.11.
Fig.12.
Fig.13.
Fig.15.
-