- 9 -
The sandblasting attachment can be used for removing
paint and rust etc.
FITTING INSTRUCTIONS
place the suction probe (A) (Fig.2.) in the abrasive.
Remove existing lance and fit the sandblasting
attachment to the handle assembly, refer to
manufacturer’s instruction manual.
CLEANING INSTRUCTIONS
Remove suction probe (A) (Fig.2.) from the
abrasive. To remove remaining abrasive, hold
water hose to nozzle (B)
(Fig.2.). This will flush the
water through the system until
clean. Dry completely before using again.
Fig.2.
A
B
SANDBLASTING
ATTACHMENT
■ STOCK No. 34452 ■ PART No. APW6
FOR USE WITH DRAPER PRESSURE WASHERS
STOCK No.61098 PART No.PW2111
STOCK No.54435 PART No.PW2121
■ STOCK No. 57358 ■ PART No. APW21
FOR USE WITH DRAPER PRESSURE WASHER
STOCK No.56456 PART No.PW2220
■ STOCK No. 57365 ■ PART No. APW28
FOR USE WITH DRAPER PRESSURE WASHER
STOCK No.56457 PART No.PW3000
■ STOCK No. 65977 ■ PART No. APW38
FOR USE WITH DRAPER PRESSURE WASHER
STOCK No.65376 PART No.PW2210
PW2111
PW2121
PW2210PW2220 PW3000
To Next Page
Loading...
