TROUBLESHOOTING
- 18 -
NOTE: Repairs should only be carried out by a qualified person.
TROUBLE PROBABLE CAUSE REMEDY
Motor will not run 1. Fuse blown 1. Remove plug from power supply and replace fuse
2. Defective on/off switch 2. Replace defective parts before using lathe again
Defective switch cord
3. Burned out motor 3. Any attempt to repair this motor may cause a
Hazard unless the repair is done by a qualified
service technician
Headstock loose on 1. Locking handle not 1. Tighten locking handle
bed tight
Wood burns at tailstock 1. Live centre too tight or 1. Back of tailstock barrel and lubricate live centre.
end not lubricated See Basic Lathe Operation “Spindle Turning”
DRAPER HELPLINE (023) 8049 4344
To Next Page
Loading...
