54
1.1 SAFETY
1.0 GENERAL
The Equipment positioning, installation and disassembly must be carried on by trained and specialized
personnel. Personnel must have carefully read and understood equipment user manuals. For installation use
standard tools only as listed in this manual. The Equipment is not suitable for installation outdoors and/or in
places exposed to atmospheric agents (rain, direct sunlight, etc.).
1.2 SYMBOLS USED IN THIS MANUAL
Refer to Appendix A sec. 6.1.
Prior to commencing any use and/or operating, personnel must have carefully read and understood this manual
to ensure a safe and intended use.
IMPORTANT NOTE:
This manual may include short description and illustrations, which are intended as guidance and summary
for parts of the operation such as i.e. the cleaning module. The Operation Manual supplied with the
cleaning module (where applicable in the actual installation), must be carefully read and understood.
Illustrations in this manual are provided to aid the basic understanding for the user and may deviate from the
actual design. This manual must be placed at the disposal of the operating and maintenance personnel at
all times. Please store these instructions as reference for operation and service. Carlsberg Breweries A/S
declines any risk and liability for operations carried out on the equipment without respecting the instructions
given in this manual and the supporting manuals for integrated equipment.
• Do not stand under suspended loads during loading/unloading operations.
• Arrange suitable area with flat floor for equipment unloading and storage operations for correct and safe
lifting operations refer to following identifications regarding weight identified on equipment.
• Do not push or pull the equipment to move it as it may tip over.
• Do not make modifications to the equipment and parts supplied with equipment.
Any missing or faulty parts must be replaced with original parts.
• The equipment must be levelled, otherwise its operation could be aected.
• The equipment has a safety valve (set at 3,3 bar) which must not be tampered with in any way.
• Never clean the plastic surfaces with acid substances or oils.
• The equipment is not suitable for installation in areas exposed to water sprays, therefore do not clean with
jets of water.
• Do not use the detergents containing chlorine, solvent-based detergents (i.e. trichloroethylene) or
abrasive powders.
See Appendix
1.3 DISCLAIMER AND NOTES
TO INSTRUCTIONS
1.4 TRANSPORTATION/HANDLING
/STORAGE
Do not remove, tamper with or make the equipment identification labels / marking illegible (also applies to
cleaning module). In case of eye contact with cleaning detergent, rinse immediately with plenty of water and
seek medical advice. Wear suitable protective clothing, gloves and eye / face protection according to local
legislation requirements. In case of accident or if you feel unwell, seek medical advice immediately (show
the label where possible). The cleaning detergent material and its container must be disposed of as hazardous
waste. Recommended safety personal protection sheet.
Protect
garments
Safety
footwear
Gloves Glasses Ear
protectors
Mask
Transport
Handling
Unpacking
Installation
Normal use
Adjustments
Routine cleaning
Extraordinary cleaning
Maintenance
Dismantling
Scrapping
CAUTION!
Safety
helmet
PPE required
PPE available or to be used
if necessary
PPE not required
To Next Page
Loading...