12 13
5.0 TROUBLE SHOOTING
5.1 FAILURE INTRO / MODES
5.2 WARNINGS
To manage the Equipment see instructions cards on cleaning modules
and keg modules, There is also provide a report to note the date of
installation (by Technician) and the cleaning process date (by Customer).
The following warnings can appear, see dedicated operation manual for cleaning module.
• CLEANING UNIT BLOCKED (with message: “error compressor” on the display)
The pressure is low on all keg modules, on the display of the cleaning unit there’s a message stating
“compressor error”.
CLEANING UNIT BLOCKED (With message: “No cleaning” on the display)
Cleaning unit does not work, on the display the picture of a the cleaning symbol bottle will appear.
NO PRESSURE ON KEG MODULES (compressor can’t fill the air)
No pressure on keg modules. One or more keg module doesn’t reach the right pressure.
5.3 OTHER FAILURES
Failures that can appear during the equipment life time or if exposed to misuse.
• WATER LEAKAGES.
Shut of the water valve and contact Technician.
NO INFO ON DISPLAY
Turn of power and turn it on again, still no Info on display contact Technician.
BUMPER RING DEFECT.
Contact Technician for new one.
GASKETS DIRTY.
Wipe the gasket clean with a clean damp cloth and do not leave any particles on a gasket if noticed,
they could result in microleaks and defects.
6.1 APPENDIX A
UNIT DRAWING/DIAGRAM
6.0 APPENDIX
To Next Page
Loading...