10
During cleaning the use of detergents with content of chlorine or substances such as thinners,
trichloroethylene, ammonia, etc. is prohibited.
IMPORTANT NOTE:
The Operating Instructions for the cleaning module must be clearly read and followed.
Below is a short illustration of the process.
Start a cleaning process shall be done as following below list.
• Open the water supply and start with cleaning mode.
• Be aware about the compressor cycles (Start/stop).
• Check cleaning flow through taps in bar (colour).
• At the end of countdown start the rinsing mode.
• At the end of the cleaning process make sure to flush with water and then move to beverage mode.
• Remove the tube from detergent bottle and tight the cap of the bottle to preserve the eectiveness of the
detergent.
WARNING:
Excess detergent might exit the tube
11
System Error:
Abnormal conditions like continuous com-
pressor operation, compressor overcurrent, a
predefined time without cleaning cycle or “bear
cut” will be monitored and can be displayed.
NOTE:
Report the date when the cleaning has been done. This to show to the Health Authorities in case of check.
Cleaning sequence may be directed by local legislation or as recommended by the Carlsberg Breweries A/S
service technicians.
HUMAN INTERFACE:
Beverage Mode:
Device is waiting for cleaning
or rinsing process by pressing
corresponding button.
Cleaning Mode:
After the default specified 20 minutes
cleaning, the device allows the operator
to switch to rinsing process by pressing
the corresponding button.
Rinsing Mode:
With 10 minutes, delay in Rinsing Mode
and according to requirement’s it is possible
to switch to Beverage or Cleaning Mode
by pressing the corresponding button.
To Next Page
Loading...