Vigor2950 Series User’s Guide
148
DHCP Server Display the current status of DHCP server of the LAN
interface.
MAC Address Display the MAC address of the WAN Interface.
IP Address Display the IP address of the WAN interface.
Default Gateway Display the assigned IP address of the default gateway.
DNS Display the assigned IP address of the primary DNS.
MAC Address Display the MAC address of the wireless LAN.
Frequency Domain It can be Europe (13 usable channels), USA (11 usable
channels) etc. The available channels supported by the
wireless products in different countries are various.
Firmware Version It indicates information about equipped WLAN miniPCi
card. This also helps to provide availability of some
features that are bound with some WLAN miniPCi card.
3
3
.
.
1
1
3
3
.
.
2
2
T
T
R
R
-
-
0
0
6
6
9
9
S
S
e
e
t
t
t
t
i
i
n
n
g
g
Vigor router with TR-069 is available for matching with VigorACS server. Such page
provides VigorACS and CPE settings under TR-069 protocol. All the settings configured
here is for CPE to be controlled and managed with VigorACS server. Users need to type
URL, username and password for the VigorACS server that such device will be connected.
However URL, username and password under CPE client are fixed that users cannot change
it.
The default CPE username and password are "vigor" and "password". You will
need it when you configure VigorACS server.
URL Type the URL for VigorACS server.
If the connected CPE needs to be authenticated, please
set URL as the following and type username and
password for VigorACS server:
http://{IP address of
VigorACS}:8080/ACSServer/services/ACSServlet
To Next Page
Loading...
Need help?
General
