Vigor2950 Series User’s Guide
173
3. Go to Remote Dial-In Users. Click on one index number to edit a profile.
4. Set Dial-In settings to as shown below to allow the remote user dial-in to build VPN
connection.
If an IPSec-based service is selected, you may further specify the remote peer IP
Address, IKE Authentication Method and IPSec Security Method for this Dial-In
connection. Otherwise, it will apply the settings defined in IPSec General Setup above.
If a PPP-based service is selected, you should further specify the remote peer IP
Address, Username, Password, and VJ Compression for this Dial-In connection.
To Next Page
Loading...
